Evaluate process (P)

To evaluate the performance indicators of the whole process, select a step of the process in the Diagram pane and then press the Evaluate button in the Evaluation group in the Analysis tab.

Note: If you were working in the Modeling view mode, Engage Process Modeler would automatically activate the Evaluation view mode after evaluation is done (see View modes).

The Results for any Stop or Sink step of the process contain values calculated under the assumption that the process ends in this step.

If a process has entry points then an entry point Results contain values calculated under the assumption that the process starts from this entry point. You can find the performance indicators for the whole process in the Process results category or in the Results category of the corresponding process element in the Project pane. Thus, if a process has only one Start and one Stop then their Results and Process results are the same.