Create Go to by dragging |
Select a Stop or Exit. Then, drag it to the process step to which you want to make the connection.
The Stop or Exit will change into a Go to step. If the connection is not visible, check the Connections box in the Show/hide group in the Layout tab.
Once a Go to step is created you can redirect it by dragging and dropping it onto another destination.
You cannot create a Go to to a Start, Stop, Sink, Join, Entry, Exit, End of expanded subprocess (phase, service).
You cannot drop a Stop, Exit or Go to step in a place that will result in an infinite loop in the process. Engage Process Modeler will show you the corresponding message.
|